Reciprocating Pumps
Application
Water supply for agriculture, shipbuilding industry as bilge-, strippin or boiler feed pump.
Design
-
up to 5 m3/h horizontal double acting with built-in relief valve, with crank shaft or gear; over 5 m3/h horizontal double acting with gear (relief valve must be installed separately) over 5 m3/h vertical version is available. Some models available with ball-valves for viscous and dirty liquids.
Connection
-
up to 5 m3/h oval flanges with threated counter flanges, other models with DIN-flanges without counter flanges.
Driver
-
electric motor, diesel engine, steam
Power transmission
-
V-belt, gearbox and flexible coupling
Bearing / lubrication
-
crank shaft, gears and all bearings oil bath-lubricated
Temperature
Capacity range
Pump pressure
-
normal version 4 up to 6 bar
-
middle pressure
-
version up to 16 bar
Suction lift
-
normal and middle pressure version up to 7,5 m
Shaft sealing
Materials
-
Gear casing: cast iron
-
Pump casing: cast iron, bronze, steel, stainless steel
-
Cylinder: brass, bronze, stainless steel
-
Valves: brass, bronze, stainless steel
-
Valve: rings rubber, buna
-
Piston rod: stainless steel
-
Piston and piston rings: cast iron, bronze, stainless steel, rubber, buna etc.
Vertical marine reciprocating pump
Mobile driven reciprocating pump
190 l/min - 220 bar